However you haveconnected an ADS or OBD connector.Solution: Modify the interface setting in Ediabas.ini.ġ.4 IFH-0003: Data transmission HOST/Interface failed Reason: In the Ediabas.ini file, the interface is set to STD:FUNK. The instructions for installing the ADS driver can be found in the “Installation Guide/Update Guide” ADS_DOKU.pdf in the directory C:\EDIABAS\Hardware\ADS\ or on the Intranet page:ġ.3 IFH-0002: Interface isn’t connected or doesn’t respond This error only occurs with an NT computer if the ADS driver hasn’t been installed. If you want to work with EDIABAS or INPA, please make sure that the COM1 port is not taken. This error occurs if another program or device has taken the COM1 port of your PC. Message comes along with an ADS or OBD connector. The following is the reasons of these problems and we will give some solutions to you solve the problems. There are some problems maybe happen during setting the driver. When you finish install BMW INPA Software, you need to connect the INPA K DCAN Interface to the computer and setting the driver, then you can diagnostic your car.
0 Comments
Leave a Reply. |